Quick Setup Guide for ATA Faxing The following steps are involved to setup an ATA user

Setup the ATA user account through the Agent Portal URL: https://secure.ipfax.net/agent.htm

Create a new user by filling in all information needed and select “Allow Fax to Fax”, put in “ATA MAC Address”, pick or specify a DID number. Make note of the UserID (number) for the User as you need this to activate the ATA as the PIN number. After your ATA user account has been setup, you need follow the steps below to activate it. It's a one-time setup.

Use the following steps to connect your ATA to the service.

      1. Connect the ATA WAN port to your network using standard RJ 45 network cable.

      2. Connect the ATA PHONE 1 port to your fax machine or analog phone using standard RJ-11 telephone cable.

      3. Connect the ATA 12VDC to the power adapter provided within the ATA box.

      4. Power it on. Wait at least 10-15 minutes.

      5. After this wait time, you should see POWER, STATUS, WAN three lights on and green.

      6. Pick up the handset of your fax or from speaker function or analog phone if you used this instead, you should see PHONE 1 light on and green, and also hear the dial tone.

      7. Dial ‘*1*UserID#’ (UserID number assigned when User created in the portal), then wait about 20-30 seconds, you should hear a voice announce that your ‘Password has been set’ and ready for faxing.

      8. Hang up the handset, the PHONE 1 light should be off.

The ATA is now ready for fax service.

707 13th Street SE, Suite, 116 * Salem, OR 97301 * USA Voice: 503-221-1111 * Fax: 503-221-3080